How to Install Bathroom Products
All our bathroom products use a custom designed adhesive wall clip mounting system. Following the 4 easy install steps ensures maximum load capacity.
Suitable surfaces
- Glossy tiles
- Matt tiles
- Glass
- Mirror
- Fiberglass (caravan showers)
Not suitable surfaces
- Laminex or similar laminated particle board.
- Porous tiles
- Painted or bare drywall
- Timber
- Small tiles with a lot of grout lines.
Four Easy Steps
-
1
Clean It
Thoroughly clean the surface, removing all soap residue and allow surface to dry completely.
-
2
Position It
Peel the backing film and position it on the wall (without touching) to get prefect alignment and level. Avoid placing the adhesive pads over grout lines.
-
3
Stick It
Firmly press the entire product into the wall. Then unclip by sliding upwards (some force required) to reveal the wall clips. Press each clip firmly into the wall and remove all air bubbles from the adhesive pad using your finger (very important step!). Once the adhesive makes contact, repositioning isn't possible without using new clips, so take your time.
-
4
Finish
Leave adhesive clips undisturbed for 12 hours, then reattach your product. That's it, you're good to go!
How to Remove Bathroom Products
- Slide the product upward and remove to expose the adhesive clips.
- Using a fingernail, tweezers or small pliers to lift and peel one corner of the adhesive pad.
- Use a hair drier on highest setting to soften adhesive. Concentrate heat on the plastic clip.
- Peel remaining adhesive pad and clip.
- Discard the used clips - each product ships with a spare set.